My Cart
Items in Cart0
Current Total$0.00
cartView Cart|Checkout


Micro9 2 Channel Butterfly Receiver - Micro9 BFly Rx 2CH
 
 
0.38g 2 Channel Receiver - Connection Diagram
 
Connection Diagram for the 2 channel Butterfly receiver.
 
Bahoma battery connection tips and advice
 
Receiver doesn't sync unless bahoma battery is squeezed or receiver quits when throttle is applied

I've got a Butterfly Receiver that powers up, but does not sync. to the TX unless I gently squeeze the battery and RX together at the bottom (bending the RX board a little). The RX works until I stop pinching the two together. I suspect a trace on the PCB is broken. Any ideas on wher I need to check for an open and perhaps solder in a jumper? I've reflowed the solder pads w/o change.
 
Beginners Recommendations for Plantraco Components
 
If you want the lightest weight R/C equipment, but have absolutely zero experience with Micro R/C or soldering or anything, and are thinking about asking if we'll solder up some of our lightest components for you as a custom job - here's what we suggest for you to do, grasshopper.
 
HingeAct Repair and Replacement on Carbon Butterfly
 
My actuator is dead - how can I repair or replace it on my model?
 
How to Solder small wires to Plantraco receivers
 
How to solder actuator wires, magnet wires, motor leads, and antennas.
 
Polarity of Receiver Bahoma Terminals
 
Which terminal is positive and negative the Micro9 2CH and 3CH receivers used on the Plantraco Butterfly models?
 
Range
 
What kind of range can I expect with the HFX900 transmitter or monolith buddy box transmitter and your 4 ch servo receiver or any of the Micro9 receivers?
 
Stripping Magnet Wire
 
How to Strip and Tin Magnet Wire
 
Transferring components from Butterfly to Carbon Butterfly
 
I would like to upgrade my old version B-fly, to the Carbon B-fly. I
do not feel that I can make component transfer without fouling it up.
If I sent in my old equipment in, would you switch it out for me?
and how much would it cost?
I also love the micro racers! The yellow jacket looks like a must
have item. So at the same time as the upgrade on the B-fly, I would
also be ordering the yellow jacket kit, and the flight pack to go
with it, and some extra batts.
 
What are some good ways to clean the magnetic electrical contacts of my receiver and Bahoma cell?
 
Tips for cleaning Bahoma magnetic electrical terminals
Results 1-10 of 1112