My Cart
Items in Cart0
Current Total$0.00
cartView Cart|Checkout


Micro9 3 Channel PlugnPlay 0.9g Receiver - Micro9 3CH 0.9gRx
 
 
0.9g 3 Channel Output Repair
 
Debugging actuator output problems on the 0.9g 3 Channel Receiver - Micro9 3CH 0.9g Rx
 
0.9g 3 Channel Receiver - Connection Diagram
 
Connection Diagram for the 0.9g 3 Channel Receiver
 
Bahoma battery connection tips and advice
 
Receiver doesn't sync unless bahoma battery is squeezed or receiver quits when throttle is applied

I've got a Butterfly Receiver that powers up, but does not sync. to the TX unless I gently squeeze the battery and RX together at the bottom (bending the RX board a little). The RX works until I stop pinching the two together. I suspect a trace on the PCB is broken. Any ideas on wher I need to check for an open and perhaps solder in a jumper? I've reflowed the solder pads w/o change.
 
How to set up Vtail or Elevon Mixing Mode
 
This solution enplanes the steps to quickly set up Vtail or Elevon on a airplane using Actuators or servos.
 
Polarity of Receiver Bahoma Terminals
 
Which terminal is positive and negative the Micro9 2CH and 3CH receivers used on the Plantraco Butterfly models?
 
Range
 
What kind of range can I expect with the HFX900 transmitter or monolith buddy box transmitter and your 4 ch servo receiver or any of the Micro9 receivers?
 
Stripping Magnet Wire
 
How to Strip and Tin Magnet Wire
 
Throttle cuts off with vibration
 
I sync up fine, when the model is throttled up or is shaken, the battery seems to lose it’s connection, Throttle cuts out, and the receiver starts up again, I can hear the tones - what’s happening?
 
What are some good ways to clean the magnetic electrical contacts of my receiver and Bahoma cell?
 
Tips for cleaning Bahoma magnetic electrical terminals