My Cart
Items in Cart0
Current Total$0.00
cartView Cart|Checkout


MicroMAV
 
 
HingeAct - Centering this magnetic actuator
 
Does the HingeAct require Magnetic centering magnets? The answer is no - the HingeAct is centered by the spring force of the plastic hinge tape itself. Also some instructions on how to center your rudder control surface that is using a HingeAct.
 
Replace the Propeller on a GB05 gearbox
 
The prop on my Zero broke. The nylon post on the large gear which it was attached to snapped clean off. What to do?
 
Flying slower - adjusting the elevator
 
Can the Micro Butterfly or MicroMAV be slowed down for livingroom flight? The videos make it look pretty fast.
 
Throttle cuts off with vibration
 
I sync up fine, when the model is throttled up or is shaken, the battery seems to lose it’s connection, Throttle cuts out, and the receiver starts up again, I can hear the tones - what’s happening?
 
Transmitter - HFX900 Transmitter - charger differences
 
Can I use my Transmitter that came with the Deluxe Starter Set for beginners with a MicroMAV or MicroButterfly. So then all I need to do is buy a MicroMAV and an LP20 cell and I'm good to go?
 
How to change props on GB05 gearbox
 
The prop adapter is glued onto the GB05 - if you want to experiment and change propellers, you need to know how to remove and install the carbon prop.
 
My actuator moves one way, but not the other way
 
Stretching HingeAct hinge and checking for friction and mechanical binding of the control surface is an important step in your pre flight checkout.