In this video we show you how to install the motor, receiver, and propeller. The motor will be held into the nose of the plane using foamsafe medium density glue. The motor goes straight on, no right thrust is required. Then add a receiver and propeller, and make sure you have the right motor direction. While the receiver is still connected, place it on the underside of the wing and do a dry fit to make sure everything is fitting nicely. Glue the receiver to the underside of the wing using foamsafe contact cement. Apply glue to the area where the receiver is going to go and then actually apply some glue to the receiver. Use a few pieces of tape to hold the antennas to the underside of the wing.

Products in this Video

MicroRacers Kit - P-51 Miss America For those looking for a speedy plane with full proportional radio control of the rudder, elevator and throttle - look no more! You can fly plane in an area the size of a tennis court. And it flies in winds up to 15 MPH - our MicroRacers love the wind! One of the great aerobatic rc planes - with its fully proportional remote control it flies like it's On Rails! Flying one of these is truly electric! Order today and learn the fun of building and flying the smallest Micro R/C models.  More info » $14.99   Buy MicroRacers Kit - P-51 MissAM Micro9 3 Channel PlugnPlay 0.9g Receiver This is our most user friendly receiver, weighing in at 0.9g including our Patent pending Bahoma connectors and .05'' (1.27mm pitch) pin and socket connectors for 2 actuators and 1 motor output. Rock Solid 900Mhz digital radio link compatible with all Plantraco Transmitters, Built-In low voltage protection, LED and Audio status indicators - A very flexible and easy to use receiver.  More info » $54.99   Buy Micro9 3 Channel PlugnPlay 0.9g Receiver